Beetle L4-1.9L DSL Turbo (ALH) (1998)
/Page-266004.png)
-
Remove Torx bolts - 1 -.
-
Remove nuts - 2 -.
-
Remove bolt - 4 -.
-
Remove control module - 5 - from bracket - 3 -.
-
Remove bracket - 3 -.
NOTE: Metal brackets must only be removed when damaged or Seat Occupied Recognition Control Module (PODS) and pressure sensor do not
fit through the opening.
-
Pass control module and pressure sensor through hole - arrow -.
NOTE: Illustration shows metal bracket after installation on seat.
-
Remove sensor mat from seat tray.
Installing
-
Before installing, observe the following notes:
NOTE:
-
Replacement mat must not be damaged when installing.
-
Stickers with notes and warnings on harness connectors must not be damaged or removed.
-
Make sure that no connections from replacement kit are disconnected while installing.
-
When reinstalling heating element in seat cushion, make sure secure seating.
-
When reinstalling seat cover to seat cushion, make sure that velcro pads adhere firmly to each other.
-
On replacement part, strap that connects sensor mat to seat cushion must not be damaged under any circumstance.
-
After installing PODS, check with the help of VAS 5051/5052 in instructions, in "Basic setting for seat occupant detection" was performed on
seat in order to match Airbag ECU and Seat sensor ECU, as well as "Seat sensor for seat occupant detection on rear seats" and if empty seat
parameters are set for seat sensor ECU.
-
Switch ignition on after installing all components.
CAUTION:
