Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Remove left-side noise insulation (arrows).
Vehicles with TDI engine
-
Remove intake air duct between charge air cooler and turbocharger.
Continued for all vehicles
-
Loosen belt pulley socket-head bolt.
Counter-hold using hex wrench if necessary.
-
Turn tensioning device indirection of arrow to relieve tension on ribbed belt.
-
Mark direction of travel of ribbed belt.
CAUTION:
-
Using a crayon or marker, mark the direction of travel before removing the ribbed belt. Reinstalling a used belt in the opposite direction could
damage the belt.
-
When installing the belt, make sure that it is correctly seated in the pulleys.
-
Remove ribbed belt.
-
Remove belt pulley socket-head bolt.
-
Clamp off suction hose using 3094 hose clamps.
-
Using VAS5024 assembly pliers, open hose clamp -3-.
-
Disconnect suction hose.
-
Remove banjo bolt -4-.