Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Mark position of marks -1- on bonded rubber bushing.
-
Assemble special tool and bonded rubber bushing.
-
Install bonded rubber bushing and special tool onto rear axle.
-
Make sure that mark aligns with edge of trailing arm.
-
Pull in bonded rubber bushing by turning spindle.
-
Check position of bonded rubber bushing after installing.
The remainder of the installation is the reverse of removal.
Fastener/location - Tightening torque
Mounting bracket to rear axle: ............................................................................................................................................................. 80 Nm (59 ft. lbs.)
Use new nuts and bolts!