Beetle L4-1.9L DSL Turbo (ALH) (1998)
/Page-1023002.png)
1
Circlip
^
Different thickness
^
Mark after removing and insert at same point
2
Thrust plate
^
Install with stepped side facing circlip
3
Inner plate
^
Quantity - Refer to Specifications
4
Outer plate
^
Quantity - Refer to Specifications
5
Pressure plate
^
Install with peened corrugated washer facing piston
6
Corrugated washer
^
Peened side to pressure plate (item 5)
7
Securing ring
^
Removing and installing refer to Fig. 1
8
Piston cap
^
Sealing lips are vulcanized to piston cap
^
Moisten with ATF before installing
^
Turn piston cap slightly when installing
^
When removing and installing press down and install securing ring (item 7)
9
Spring
^
Seat between piston and piston cap
10 Piston
^
Sealing lips are vulcanized to piston
^
Moisten with ATF before installing
^
Turn piston slightly when installing
11 Clutch housing with turbine shaft Height varies according to number of inner and outer plates
12 O-ring
^
Always replace
^
Installing refer to Fig. 4
13 Piston ring
^
Be sure piston ring is correctly located refer to Fig. 2
^
Installing refer to Fig. 3
