Beetle L4-1.9L DSL Turbo (ALH) (1998)
Wiring Harness: All Technical Service Bulletins
A/T Controls - MIL ON/DTC 00297 Stored in Memory
Condition
01 07 16 Jan. 29, 2007, 2002394, Supersedes Technical Bulletin Group 01 number 99-09 dated June 1, 1999 due to inclusion into ElsaWeb and updated
content.
Customer States MIL ON, DTC 00297 Gearbox Speed Sender -G38- Stored in TCM DTC Memory
The Malfunction Indicator Light is illuminated and DTC 00297 Gearbox Speed Sender -G38- is stored in Transmission Control Module (TCM) DTC
memory. No obvious fault has been found with Gearbox Speed Sender -G38-.
Tip: The Gearbox Speed Sender -G38- will not effect the vehicle speedometer or cruise control operations.
Tip: If DTC 00281 Road Speed Sender -G68- is stored in TCM memory, also install -G68- overlay harness as outlined in Technical Bulletin instance
2002393 (Customer States MIL ON, DTC 00281 Road Speed Sender -G68- Stored in TCM DTC Memory).
Technical Background
Not Applicable.
Production Solution
Not Applicable.
Service
Install -G38- overlay harness Part No: 1C0971661 as follows:
Engine compartment harness covers, removing
-
Obtain radio code and preset radio stations.
-
Disconnect battery ground (GND) strap.
-
Remove battery and battery tray (see Repair Manual Group 27).
-
Remove air cleaner housing (see Repair Manual Group 24).
-
Remove engine wiring harness covers.
Gearbox Speed Sender -G38-, replacing and removing existing connector
-
Locate Gearbox Speed Sender -G38- and replace.
-
Cut connector and wires from main harness (near taped section of harness).
Plenum covers, removing
Remove inner plenum panel covers as follows: