Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Turn clutch pedal limit stop -A- in direction of arrow and remove.
- Push slave cylinder in direction of arrow -1- until stop.
-
It must not be covered in the upper area by the over-center spring mounting (arrow -2-)
- Swing slave cylinder in direction of arrow -3- out of mounting bracket.
Installing
Install the clutch slave cylinder in the reverse order of removal and note the following:
- Install retainer -A- to master cylinder operating rod -B-.
- Press clutch pedal in direction of arrow to engage. Ensure correct location.
- Insert clutch pedal limit stop -A- again.
-
Installation position: The arm (arrow) must point towards master cylinder -B-.
- Bleed clutch system after installing master cylinder.