Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Press on joint up to stop.
-
Install circlip.
-
Chamber on inner diameter of ball hub (splines) must face contact shoulder on axle shaft
Fig. 6 Installation position of CV joint boot on left axle shaft
Dimension -a-: 17 mm (0.669 inch)
Note: Before assembling the CV joint boot on the axle shaft, mark position (dimension -a-) using paint or adhesive tape. Do not damage the paint
(scratch or score paint surface) by using a sharp tool.
Fig. 7 Installation position of CV joint boot on right axle shaft
-
Vent chamber -A- must seat on tube
B -Vent hole
Fig. 8 Tightening clamp on outer CV joint
-
Install VAG1682 CV joint boot clamp tool as shown in illustration. Make sure that jaws of pliers seat in corners (arrows -B-) of clamp.
-
Tighten clamp by turning spindle using torque wrench (do not cant pliers).
Tightening torque: 20 Nm (15 ft. lbs.).
Note: