Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
VW 454 Thrust tube
-
41-501 Drift sleeve
-
VW 447 1 Thrust pad
-
VW 510 Thrust pad
Note:
- When Installing new gears, consult technical data.
- If the position of the tapered roller bearings is affected when replacing parts, the input shaft must be re-adjusted.
1
Clutch Housing
2
Tapered roller bearing outer race
3
Tapered Roller bearing inner Race
-
Drive off shaft with drift
4
Input Shaft
5
3rd Gear
-
Shoulder points to 4th Gear
6
Circlip
-
Always Replace
7
4th Gear
-
Pressing off with tapered roller bearing outer race and sleeve
-
Collar faces 3rd gear
8
Tapered Roller bearing inner race
-
Pressing off with 4th gear and race
9
Thrust Washer
10
Taper Roller Bearing outer race
11
Shim
12
Transmission housing
13
Sleeve
-
For needle roller bearing
-
Press off with 4th gear and tapered roller bearing inner race Fig 4
-
Pressing on refer to Fig. 9
-
Place, thrust washer or before installation, (item 9)
14
Needle roller bearing
15
5th gear
-
Pull off together with 5th gear synchronizer hub
16
5th gear synchronizer ring
-
With cast locking pieces
-
Checking for wear
17
Spring