Beetle L4-1.9L DSL Turbo (ALH) (1998)
1
Selector shaft
2
Stop ring
3
Ball sleeve
-
Removing Fig. 1
-
Pressing in Fig. 2
4
Oil seal
-
Pry out with screwdriver
-
Installing =refer to Fig, 3
5
Selector mechanism cover
6
Sleeve
-
Offset shoulder points to back-up light switch
-
Lightly coat shoulder with MoS2 grease
7
Nut
-
25 Nm (18 ft. lbs.)
-
Self-locking
-
Always replace
8
Housing
-
For back-up light switch
9
Bolt
10
Cap
-
For transmission breather
11
Sleeve
-
Drive in onto stop if present as an individual part
12
Gear selector lever
-
Install so that master spline aligns with selector shaft
-
Can be replaced with selector mechanism installed
-
Installation position
13
Relay lever
-
Installation position.
14
Nut
-
15 Nm (11 ft. lbs.)
15
Actuating arm
-
With axis pin for mounting relay lever
-
Installation position
16
Bolt
-
Press into actuating arm
17
O-ring
-
Pull onto actuating arm axis pin
18
Spacer