Beetle L4-2.0L (AEG) (2000)
-
Fit assembly tool 2036 and adjust mountings to height of studs.
-
Screw pressure hose VW 653/3 into spark plug thread.
-
Connect pressure hose to an air system with at least 6 bar (87 psi).
-
Remove valve springs with VW 541 /1A lever and VW 541/5 press piece.
Note: Tight keepers can be loosened by lightly tapping on the over.
-
Pull off valve stem seals using tool 3047A.
Installing
-
Place plastic sleeve -A- (supplied with replacement part) on appropriate valve stem.
^
This will prevent the new valve stem seal -B- from being damaged.
-
Insert new valve stem seal in 3129 installation tool.
-
Oil valve stem seal sealing lip and press carefully onto valve guide.
-
Install camshaft.