Beetle L4-2.0L (AEG) (2000)
With Engine Removed:
-
Turn vibration damper to cyl. 1 TDC -arrows-.
Continuation For Both
-
Lay toothed belt on tensioner and camshaft gear.
Toothed Belt, Tensioning
Requirements
^
The Engine must be no more than warm to the touch.
^
Crankshaft is at TDC, cylinder 1.
^
Before tensioning the toothed belt, turn the tensioning roller eccentric pulley using the pin wrench -T10020- five times all the way in both
directions.
Procedure
-
Tension camshaft drive belt. Do this by turning eccentric to left (direction of arrow) with 2-hole pin wrench T 10020 onto stop.
-
Release the toothed belt tension until the notch -1- and indicator -2- align. (Check using mirror).
-
Tighten securing nut to 20 Nm (15 ft. lbs.)
-
Continue turning crankshaft two turns in the direction of engine rotation until the engine is again at TDC cyl. 1. When doing this it is important
that the last 45° (1/8 turn) turn is performed without stopping.
-
Check the direction one more time, specified value: arrow and notch are aligned.
Continuation, Installing the Complete Toothed Belt
-
Install center and lower part of the toothed belt cover.
-
Install the vibration damper/belt pulley, torque securing bolts to 25 Nm (19 ft. lbs)
-
Install engine bracket on cylinder block, torque securing bolts to 45 Nm (33 ft. lbs).
Note:
^
Before installing engine bracket, insert bolts in bracket.
^
Before the assembly mounting can be installed, all bolts for bracket must be tightened to 45 Nm (33 ft. lbs).
-
Install subframe mount for engine for engine completely.