Beetle L4-2.0L (AEG) (2000)
Only engine code AEG
Engine code AVH, AZG
-
Remove fuse 32 from fuse panel.
-
Pull connectors off outer injectors.
-
Remove spark plug connectors using T10029 tool and place spark plug wires aside.
-
Remove spark plugs using 3122 B tool.
-
Have a second technician operate starter.
-
Vehicles with engine code AEG: fully depress accelerator pedal using a second technician.
-
Check compression using VAG1763 tester.
Note: Compression tester operation instructions Tester Operators Manual
-
Crank starter until tester shows no further increase in pressure.
Compression pressure:
^
New: 10 to 13 bar (145 to 189 psi)
^
Wear limit: 7.5 bar (109 psi)
^
Maximum permissible difference between all cylinders:
^
3 bar (43.5 psi)
-
Finally, erase engine control module DTC memory because pulling off injector connectors will have caused a DTC to be recorded.
-
Check Diagnostic Trouble Code memory, Refer to Powertrain Management
-
Check Readiness code.
-
Reset Readiness code after DTC's are corrected, Engine Control Module (ECM) is subject to low voltage with ignition on, or ECM is replaced.