Beetle L4-2.0L (AEG) (2000)
06A906018AB Motronic M5.9.2 HS V06 ->
Coding 00000
WSC 00000
-
Press -> button.
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press 0 and 8 buttons to select "Read Measuring Value Block" function 08.
-
Press Q button to enter input.
Indicated on display
Read measuring value block
Input Display group number XXX
-
Press 0, 0 and 3 buttons to select "Display group 3."
-
Press Q button to enter input.
Indicated on display (1 to 4 = Display fields)
Read measuring value block 3
->
1
2
3
4
-
Observe Throttle valve angle in Display field 3.
-
Slowly open Throttle valve to Wide Open position and observe ignition angle in Display field 3.
-
Value must increase uniformly over complete range.
If specification obtained
-
Press -> button.
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press 0 and 6 buttons to select Function 06: "End output"
-
Press Q button to enter input.
-
Switch OFF ignition.
NOTE: The displayed value is dependent on the Throttle Position sensor tolerances and does not correspond to the actual opening angle.
If value does not increase uniformly
-
Replace Throttle Control Module J338.
-
Match Engine Control Module to Throttle Control Module.