Beetle L4-2.0L (AEG) (2000)
socket 63: Wire resistance: max. 1.5 Ohms
Continuation for all vehicles
-
Also check wires for short circuit to B+ and Ground (GND): Specified value: Infinite Ohms
-
Check wire between 4-pin connector terminal 1 and Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram: Wire resistance:
max. 1.5 Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
With Manufacturer Scan Tool
Oxygen Sensor Heating (After Three Way Catalyst), Checking
Special tools, workshop equipment, testers, measuring instruments and auxiliary items required
-
VAG 1551/1552 Scan Tool using VAG 1551/3 Adaptor cable
-
VAG 1598/22 Test Box
-
Fluke 83 multimeter
-
VW 1594 Adaptor kit
-
Wiring diagram
Requirements
-
Fuse 43 must be OK
-
Battery Voltage must be 11.5 Volts minimum
-
Fuel pump relay must be OK
-
Engine Coolant Temperature must be 85 °C minimum See Display group 04, Display field 3
Test sequence
-
Connect VAG 1551/1552 Scan Tool. Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks" See: Testing and Inspection
-
Start engine and let idle.
-
Press 0 and 1 buttons to select "Engine Electronics" address word 01.
Indicated on display (example only)
06A906018AB Motronic M5.9.2 HS V06 ->
Coding 00000
WSC 00000
-
Press -> button.
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press 0 and 8 buttons to select "Read Measuring Value Block" function 08.
-
Press Q button to enter input.