Beetle L4-2.0L (AEG) (2000)
Throttle drive G186 and Throttle drive angle sensor G187, continuation
-
Disconnect harness connector -1- from Throttle Control Module -2-.
-
Measure Throttle Drive resistance between connector terminals 7 + 8.
-
Specification: 3 to 200 Ohms
-
Check Voltage supply of Throttle Control Module and wiring to Control Module.
If no malfunction detected
-
Replace Throttle Control Module J338.
-
Match Engine Control Module to Throttle Control Module.
Throttle Position sensor G69, checking
Requirements
-
Engine Coolant Temperature must be 85 °C minimum See Display group 04, Display field 3
Test sequence
-
Connect VAG 1551/1552 Scan Tool. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Scan Tool Connecting
-
Switch ON ignition.
-
Press 0 and 1 buttons to select "Engine Electronics" address word 01.