Beetle L4-2.0L (AEG) (2000)
-
Unscrew protective cover (arrows) and disconnect 4-pin harness connector (black) -1- to Heated Oxygen Sensor (HO2S) -G39- before catalytic
converter.
-
Connect multimeter to terminals 3 + 4 of connector to Engine Control Module (ECM) for voltage measurement.
-
Switch on ignition and measure primary voltage.
Specified value: 0.400 to 0.500 Volts
-
Switch ignition off.
If specified value is not obtained:
-
Test oxygen sensor wires.
If specified value is obtained:
-
Replace Heated Oxygen Sensor (HO2S) 1 Bank 1 -G39- before catalytic converter, item 9.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles
and Readiness Codes
Checking oxygen sensor wires
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box,
Connecting For Wiring Test