Beetle L4-2.0L (AEG) (2000)
Fig. 2 Plug seal, replacing
^
Cut open seal -arrow- with side cutters, always replace seal.
^
After repairs are completed, install new seal on plug and screw in hand-tight to fill with ATE
^
Fill with 3 L (3.16 qt) of ATE then check ATE level and top-up.
Fig. 3 Conductor strip, removing
^
Place 3373 onto stop under the solenoid valve plug.
^
Remove plug with 3373 in direction of arrow.
^
Remove bolt -1-.
Fig. 4 Valve body, removing and unhooking operating rod
When removing the valve body, the manual selector valve -1- remains in valve body.
^
Shift selector lever/shaft to position "1"
^
Full manual selector valve out until it is just possible to unhook operating rod -2-.
^
Secure manual selector valve so that it cannot fall out
Fig. 5 Sealing plug, installing
Remove sealing plug from housing before removing and installing free wheel, otherwise sealing plug and O-ring will be damaged.
^
Install O-rings to sealing plug.
^
Insert sealing plug in hole in transmission housing -arrow-.