Cabrio GL L4-2.0L (ABA) (2001)
Convertible Top Pump: Service and Repair
Oil Reservoir, Removing and Installing
Oil Reservoir, Removing And Installing
Removing
-
Remove hydraulic pump.
-
To remove, loosen Torx bolts - 1 - and catch escaping oil while doing so.
-
Remove Torx bolts - 1 - and carefully remove oil reservoir - 2 - from hydraulic pump - 4 -
CAUTION: Before removing oil reservoir, place a container under pump and catch escaping oil.
Installing
-
Coat O-ring - 3 - with hydraulic oil and insert into groove on pump housing.
-
Coat oil reservoir - 2 - on inside in area of O-ring with hydraulic oil.
-
To install, slide on oil reservoir using turning motions and always tighten new Torx bolts - 1 - (2 Nm).
CAUTION: Always observe torque, otherwise oil reservoir will be damaged.