volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Fuel Injectors, Checking|Page 4301 > < Fuel Injectors, Checking|Page 4299
Page 1
background image

Fuel Injector: Testing and Inspection
Injectors For Leaks And Quantity Injected, Check

Check Injectors For Leaks And Quantity Injected

Special tools and equipment

-

VAG 1348/3 Remote control

-

VAG 1348/3-2 Adapter

-

VAG 1602 Calibration tester

Test conditions

-

The fuel pressure must be in order, checking See: Fuel Pressure Regulator/Testing and Inspection.

WARNING:  Fuel system is under pressure! Before opening the system place a cloth around the connection. Then release pressure by carefully
loosening the connection.

Test sequence

-

Remove intake manifold upper section.

-

Pull connector off all injectors.

-

Remove fuel rail securing bolts.

-

Pull off vacuum hose from fuel pressure regulator.

-

Lift fuel rail with injectors off intake manifold and support it.

Checking for leaks

-

Initiate Output Diagnostic Test Mode (DTM) and activate cylinder 1 fuel injector -N30- ; fuel pump must run. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures

NOTE:  This work sequence allows the fuel pump to run when the engine is not running. The idle speed switch must remain closed for this check,
otherwise the selected injector will inject 5 times. Check injector for leaks (visual check).

-

Check injector for leaks (visual check). Only 1 to 2 drops per minute must emit from each valve when fuel pump is running.

Fuel Injectors, Checking|Page 4301 > < Fuel Injectors, Checking|Page 4299