Cabrio GL L4-2.0L (ABA) (2001)
/Page-1387003.png)
complete unit
Note:
^
Pumps supplied as replacement parts are not filled with oil. Fill pump with hydraulic oil Part No. G 002 000 and rotate by hand, otherwise pump
may be damaged or noisy during operation.
^
Type of oil: hydraulic oil Part No. G 002 000
^
Oil system capacity: 0.7 ... 0. 9 ltr (11.8 - 15.2 oz.)
Removing
-
Remove noise insulation.
-
Loosen belt pulley hex bolt.
-
Counter-hold with a hex key if necessary.
-
Turn tightening device in direction of arrow to relieve tension on ribbed belt.
For ease of illustration, relieving belt pulley tension is shown with out charge air line.
-
Mark ribbed belt direction of rotation.
-
Remove ribbed belt.
-
Remove hex bolt from belt pulley.
Suction line and hose, removing
Suction line lower spring clip can only be opened with headlight removed.
Remove bumper for this.
-
Pull connector off intake line.
-
Open spring clamps -1-, -2- and -3- with special tool VAS 5024.
