Cabrio GL L4-2.0L (ABA) (2001)
-
Unclip brake cable (arrows).
-
Remove clips -2- on both sides.
-
Disconnect brake lines.
-
Remove brake caliper housing bolts -A-.
-
Remove connector -1 -from speed sensor.
-
Unclip speed sensor wiring from retainer.
-
Support rear axle.
For example, with transmission jack VAG 1383 A,
-
Remove bearing bracket bolts -1- on both sides of rear axle, and lower rear axle.
Installing
-
Bleed brakes.
Grease bonded rubber bushings
-
Grease bonded rubber bushings with assembly paste before installing rear axle.
-
Install in reverse sequence
-
Check steering wheel position during test drive.
-
Check wheel alignment if steering wheel is not in straight ahead position.
Tightening torque: