Cabrio GL L4-2.0L (ABA) (2001)
1. Supporting ring
^
4-piece, unclip from inner plate carrier
^
Inserting refer to Fig. 2
2. Inner plate carrier
^
Inserting refer to Fig. 4
^
Assembling refer to Fig. 2
3. Circlip
^
Different thickness
^
Mark after removing and insert in same position
4. Thrust plate
^
Smooth side faces inner plate
^
Insert together with inner plate carrier refer to Fig. 2
5. Inner plate
^
Quantity. Refer to Application and ID.
^
Installing refer to Fig. 2
6. Outer plate
^
Quantity Refer to Application and ID.
^
Installing refer to Fig. 2
^
Always 1.5 mm thick
7. Outer plate
^
Always 2 mm thick
^
Installing refer to Fig. 2
8. Corrugated washer
9. Circlip
^
Removing and installing refer to Fig. 1
10. Piston cap
^
Seals are vulcanized to cap
^
Moisten seals with ATF before installing
^
Turn cap slightly when installing
11. Intermediate spring ring
^
With spring supporting shell and compression springs
12. Piston
^
Seals are vulcanized to piston
^
Moisten seals with ATF before installing
^
Turn piston slightly when installing
13. Clutch housing
^
Before inserting inner plate carrier corrugated washer (item 8), insert inner and outer plates in clutch refer to Fig. 3