Cabrio GL L4-2.0L (ABA) (2001)
-Remove circlip
1. Pliers VW 161 A or available commercially
-
Place axle shaft in press.
-
Hold axle shaft, press triple roller star off shaft.
-
Remove triple roller star with roller and place on clean surface.
-
Remove CV joint from axle shaft.
-
Remove sleeve from axle shaft.
-
Clean shaft and CV joint.
Assembling
-
Slide small clamp and boot for CV joint on shaft.
-
Slide CV joint on shaft.
Assembling triple roller star
-
Install triple roller star, (chamfer on star faces shaft),
-
Press star in to stop.
-
Install lock ring, and ensure lock ring clicks into groove.
-
Press in 60 grams (2.1 ounces) of grease G 000 633 (from repair set) into triple roller star.
-
Slide CV joint over roller and hold.
-
Press in 60 grams (2.1 ounces) of grease G 000 633 (from repair set) into back side of triple roller star.
-
Slide CV joint boot in place, bead in boot must lock into groove of CV joint.