Cabrio GLX L4-2.0L (ABA) (2001)
Front Door Window Regulator: Service and Repair
Window Regulator, Removing And Installing
Removing
-
Front door trim panel removed and insulating film loosened.
-
Remove inner window recess seal from flange.
-
Lower door window and unbolt door window.
-
Pull door window upward, tilt forward and lift out of window recess.
-
Unclip clip - arrow - for Bowden cables.
-
Loosen bolts - 1 - and remove bolts - 2 - (10 Nm).
-
Raise window regulator slightly so that bolts - 1 - can be removed through installation holes.
-
Remove window regulator downward from installation opening.
-
For electrical window regulator, slide harness connector - 1 - in direction of - arrow and disconnect.
Installing
-
Installation is reverse order of removal.