Cabrio GLX L4-2.0L (ABA) (2001)
Trunk / Liftgate Lock Cylinder: Service and Repair
Lock Cylinder Housing, Removing and Installing
Lock Cylinder Housing, Removing And Installing
Removing
-
Remove rear lid trim.
-
Disconnect connector - 3 -.
-
Unclip operating rods - 1 - and - 2 - on lock cylinder housing.
NOTE:
-
Lower spring mount can be damaged during collision repair.
-
If this is case lock cylinder housing must be replaced.
-
Installation must therefore be performed carefully.
-
Use screwdriver to lift retaining clip - 1 -.
-
Pry retaining clip - 1 - over lock cylinder housing mount with screwdriver.