Cabrio GLX L4-2.0L (ABA) (2001)
Wheel Speed Sensor On Rear Axle (Drum Brakes), Removing And Installing
Removing
-
Raise vehicle.
-
Disconnect wheel speed sensor and speed sensor wiring connector -1-.
-
Remove bolt -2- from stub axle.
-
Pull ABS wheel speed sensor out of stub axle.
Installing
-
Before inserting speed sensor, clean mounting hole inner surface and coat speed sensor with lubricant G 000 650.
-
Insert speed sensor into hole in stub axle and tighten bolt to 8 Nm (70 inch lbs.).
-
Connect speed sensor to speed sensor wiring.
ABS Wheel Speed Sensor Wiring To Rear Axle, Removing And Installing
Required Special Tools
^
VAS 1978 Wiring harness repair set
Removing
-
Obtain radio code on vehicles with coded radio.
-
Disconnect battery
-
Disconnect wheel speed sensor wiring connector.
-
Remove rear interior side panel trim.
-
Strip insulation (arrow) from shrink connection.
-
Cut speed sensor wiring in front of spliced connection with stripping pliers from VAS 1978 wiring repair kit and remove faulty wiring.