Cabrio GLX L4-2.0L (ABA) (2001)
Engine Mount: Service and Repair
CAUTION: Engine and transmission must be supported by 10-222A engine support bridge before loosening bolts.
Engine/transmission mounts
Engine/Transaxle Mount Alignment Points
- With the engine lifting device connected align guide pins on right rear mount (left) and front mount (right) to recesses on brackets (arrows).
Replacing front cross member rubber bushings
- Install 1O-222A engine support bridge with 1O-222A/1 bracket for engine.
- Connect engine sling in hook eye on cylinder head (left side) and tighten to lift engine slightly.
- Remove front cross member.
- Pry washers off spacer sleeves with pliers.
- Remove spacer sleeves and pull off bonded rubber bushings.
- Install new bonded rubber bushings and insert spacer sleeves as far as possible.