Cabrio GLX L4-2.0L (ABA) (2001)
Air Flow Meter/Sensor: Locations
Injection System Components, Removing and Installing
Injection System Components, Removing And Installing
1
Air cleaner
2
Mass Air Flow (MAF) sensor -G70-*
-
5 pin connector
3
To EVAP Canister Purge Regulator Valve -N80-*/**
-
EVAP system
4
Intake hose
5
Heater element -N79-
-
For crankcase breather
-
Resistance at ambient temperature (approx. 25 degree C): Specification: 7 to 12 Ohm
6
Crankcase breather pressure regulating valve
7
Intake manifold - upper section
8
Throttle valve control module -J338-*
-
5-pin connector
-
If replaced match engine control module
-
If replaced adapt control module for automatic transmission:
9
Connector, 28 pin
-
Only disconnect or connect with ignition switched off
-
Release to disconnect
10
10 Nm
11
Bracket
12
Motronic Engine Control Module (ECM) -J220-*
-
Installed location: In plenum chamber
-
Checking voltage supply
-
Procedure after voltage supply open circuit
13
Connector, 52-pin
-
Only disconnect or connect with ignition switched off