Cabrio GLX L4-2.0L (ABA) (2001)
Ignition Switch Lock Cylinder: Service and Repair
WARNING: Special safety precautions and some different procedures apply to vehicles equipped with airbags.
Removing:
-
Remove steering lock housing.
-
Mark steering lock housing for hole at intersection of points -a- and -b-.
-
Dimension -a- = 12 mm (15/32 in.)
-
Dimension -b- = 10 mm (25/64 in.)
-
Drill 3 mm (1/8 in.) diameter hole into steering lock housing at mark until lock cylinder stop spring is visible.
Hole depth: approx. 3 mm (1/8 in.)
-
Compress stop spring using opposite end of drill and pull out lock cylinder.
Installing:
-
Insert lock cylinder into steering lock housing.
-
Insert key into lock cylinder.
-
Push lock cylinder fully into housing while gently turning key.