Cabrio GLX L4-2.0L (ABA) (2001)
Tie Rod: Service and Repair
Revised Tie Rod End, Identifying
Revised Tie Rod End, Cabrio
From VIN_1ES 000 001, all the Cabrio vehicles are equipped with a revised tie rod end with a new pin that is 3mm (1/8 in) longer than the previous
pin. Only these revised tie rod ends will be supplied as replacement parts.
For vehicles up to VIN_1ER 030 000, if one tie rod end is to be replaced with the newer revised tie rod end, then both tie rod ends must be replaced.
CAUTION: DO NOT install two different types of tie rod ends in the same vehicle.
For vehicles from VIN_1ER 030 000, equipped with the revised tie rod end, individual tie rod ends can be installed.
Identifying tie rod ends
Up to VIN_1ER 030 000:
1
Manufacturer: TRW Vehicle Systems
Centered mark on pin (arrow -A-)
Manufacturers mark "ECO" on lower side
2
Manufacturer: Lemfoerder Metallwaren
Conical recess on pin (arrow -B-)
Manufacturers mark "LMO" or "LME" on lower side
Up to VIN_1ES 000 001:
1
Manufacturer: TRW Vehicle Systems
Cylindrical recess and centered mark on pin (arrow -A-)
Manufacturers mark "ECO" on lower side