Cabrio GLX L4-2.0L (ABA) (2001)
-
Press tabs of retaining clip together (arrows).
-
Pull locking cable out of selector mechanism.
Installing
Note:
^
When installing ensure locking cable routing is correct refer to Fig. above under Removing.
^
Take care not to kink locking cable.
^
Adjust locking cable after installing.
-
Move selector lever to "P".
-
Press locking cable into support bracket on selector lever housing until tabs on retaining clip (arrows) spread.
-
Attach locking cable in locking lever.
-
Turn ignition ON.
-
Push locking cable into steering lock.
-
Push clip into locking cable.
-
Ensure clip is properly located.
-
Locking cable, adjusting. See: Adjustments