Cabrio GLX L4-2.0L (ABA) (2001)
-
Tighten 12-point nut to 300 Nm (221 ft lb) and then loosen 1/2 turn.
Note:
^
Torque 50 Nm (37 ft 1b) + turn 45° further
^
To tighten 12-point nut use wrench VAG 1756.
If wrench is not available, 12-point nut can be tightened as follows.
-
Lower vehicle so wheels are on floor.
-
tighten 12 point nut with 300 Nm (221 ft lb) and loosen 1/2 turn
-
Mark point on nut with line (arrow A).
-
Mark 2nd line (arrow B) on edge of wheel hub above point.
Distance between each point is 30°.
-
Tighten 12-point nut until both lines align.