Cabrio GLX L4-2.0L (ABA) (2001)
1-Self-locking 12-point nut
^
Tightening refer to Axle Shaft Assembly, Constant Velocity Type; Axle Shafts, Removing and Installing.
^
Any paint residue and/or corrosion on outer joint thread must be removed before nut is installed.
2-CV joint boot
^
Check for punctures and chafing
3-Clamp
^
Tightening Axle Shaft Assembly, Constant Velocity Type; Axle Shaft With Constant Velocity Joint, Servicing.
^
Always replace
4-Multi-point socket head bolt
^
M8 40 Nm (30 ft lb)
^
M10 80 Nm (59 ft lb)
5-Triple roller joint housing
6-Triple rotor star
^
Chamfer (arrow) faces opposite end of axle
7-Circlip
^
Always replace
8- 0-ring
^
Always replace
9-Cover
^
Always replace
10-Clamp
^
For triple rotor star
^
Installed to left side
11-CV joint boot
^
Check for punctures and chafing
12-Axle shaft
13-Spring washer
^
larger diameter faces thrust washer
14-Thrust washer
15-Circlip
^
Install in shaft groove
^
Always replace
16-Outer constant velocity joint
^
Removing refer to Axle Shaft Assembly, Constant Velocity Type; Axle Shaft With Constant Velocity Joint, Servicing.
^
Installing: drive onto shaft with plastic hammer until compressed circlip seats
^
Only replace complete
^
Greasing refer to Axle Shaft Assembly, Constant Velocity Type; Axle Shaft With Constant Velocity Joint, Servicing.
^
Checking refer to Testing and Inspection.