volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Coolant Indicator LED - Flashing At Normal Temp|Page 4515 > < Temperature Sensor (Gauge)|Locations
Page 1
background image

Temperature Warning Lamp/Indicator: Customer Interest
Coolant Indicator LED - Flashing At Normal Temp

Group:

90

Number:

92-03

Date:

Feb. 29, 1992

Subject:
Coolant Indicator LED is Flashing at Normal Temperatures

Model(s):
All Models

Condition

Coolant overheat / low coolant level indicator LED is flashing at normal coolant temperatures.

Service

Check the coolant indicator LED according to the list below. The following applies in addition to tests listed in the Service Microfiche.

^

refer to appropriate wiring diagram

^

disconnect coolant level sensor electrical connector

^

check coolant level in coolant reservoir

^

MUST be between MIN and MAX marks

^

set digital multimeter, Fluke 83 (US 1119) to ohms function

^

check resistance of level sensor with digital multimeter Fluke 83 (US 1119)

^

must be between 31K Ohm and 65K Ohm with correct coolant leveland coolant concentration.

Note

If coolant resistance is NOT within the above specification, the coolant MUST be drained and replaced with NEW coolant mixture of 50% water and
50% phosphate free coolant antifreeze, Part No. ZVW 237 104. (In Canada use Part No. G 001 100) The mixing should be performed before filling
vehicle coolant system.

CAUTION

Coolant concentrations of 60% or higher will cause the overtemp. / low coolant LED to activate.

CAUTION

Coolant antifreeze MUST NOT be reused. Properly dispose of used coolant.

^

reconnect sensor connector

^

check coolant level control unit using wiring diagram

Note

The control unit is located on top of the fuse/relay panel on vehicles up to 1989 m.y. and thereafter it is integrated into the multi-processor of the
instrument cluster circuit board.

^

if wiring, coolant level sensor and coolant concentration are OK, replace coolant level control unit or instrument cluster circuit board

^

refer to appropriate Service Microfiche Group 90 - Coolant Temperature Guage, checking and troubleshooting

^

confirm proper operation of temperature gauge and blinking LED per Service Micofiche Group 90

CAUTION

Coolant Indicator LED - Flashing At Normal Temp|Page 4515 > < Temperature Sensor (Gauge)|Locations