Cabriolet L4-1781cc 1.8L SOHC (JH) (1989)
-
adjust intermediate gear shaft and tighten by hand
-
Insert spark plug socket wrench in intermediate gear shaft (12 point opening)
-
make final adjustment by tightening intermediate gear shaft 1½ points (arrow)
-
install locking plate
-
insert differential and install side cover
-
install adjusting ring and tighten by hand
-
make final adjustments by turning adjusting ring 3 notches In (arrow)
-
measure total turning torque on pinion shaft; reading must be between 320-600 Ncm (28-52 In. lb.)
-
install locking plate for adjusting ring
Drive Flanges / Differential Housing Covers, Modified
Some vehicles with automatic transmissions have 100 mm (3.94 in.) diameter constant velocity joints
Drive flanges and differential housing covers have been modified to accommodate this change
Fig. 1 Drive flange, dimensions
-
Current drive flange a = 90 mm (3.54 in.)
-
Modified drive flange a = 100 mm (3.94 in.)