Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Alarm Module: Service and Repair
Towing Recognition Control Module
Towing Recognition Control Module
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1783)
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove left luggage compartment trim.
-
Release the connectors - arrows - and disconnect them from the Towing Recognition Control Module (J345).
‹› For removal, bracket - 1 - must not be removed.
‹› The number of connectors on the towing recognition control module can deviate from the illustration depending on the vehicle equipment.
-
Remove the mounting bolts - 2 - (2 Nm) and remove towing recognition control module from vehicle.
Installing:
Install in reverse order of removal, noting the following:
-
Tighten all threaded connections to the specification. Refer to => [ Towing Recognition Control Module Tightening Specifications ] See: Tow
Sensor/Specifications.
‹› After installing a new towing recognition control module, it must be coded. Refer to => [ Towing Recognition Control Module, Coding ] See: Tow
Sensor/Testing and Inspection/Programming and Relearning.