Eos (1F7) L4-2.0L Turbo (BPY) (2007)
^
Observe the lower lip of the seal.
NOTE:
Adhesive -arrows- must be applied to windshield frame (from A-Pillar to A-Pillar) above seal lower lip mating surface and over top of seal
guide holes.
^
Apply protective tape across top of header bar prior to adhesive application.
^
Insert Dispenser tip 3-4 mm below header bar upper surface.
^
Using Dispenser Part No: VAG 1628, apply a 3 mm bead of 3M adhesive Part No: 3M 08690 to entire length of windshield frame (A-Pillar to
A-Pillar).
TIP:
For easy application, apply adhesive at temperatures approximately 75°F. In cold climate areas let vehicle stay over night indoors.
^
Remove protective tape.
^
Remove any excess adhesive with general purpose cleaner Part No: D00940104 and a clean cloth.
^
Recap adhesive tube and preserve for future use.
^
Secure seal to windshield frame at the A-Pillars.
^
Begin by attaching tape to seal and wrap toward front of vehicle.