Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Convertible Top Position Sensor / Switch: Service and Repair
Roof Pillar Front Position Sensors
Roof Pillar Front Position Sensors
‹› All screws are microencapsulated and must always be replaced.
-
Open roof.
-
Remove A-pillar trim.
-
Remove screw - 2 - and remove sensor - 1 - from lock fitting - 4 -.
When replacing sensor, disconnect wire - 3 - approximately 350 mm from sensor. After repairing wiring harness, wiring must be secured in harness
again.
Tightening specification for screw - 2 -: 3 Nm.
Roof Pillar Lock Sensors
Roof Pillar Lock Sensors
‹› All screws are microencapsulated and must always be replaced.