Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Connecting Rod: Locations
Piston and connecting rod, assembly overview
1. Connecting rod bolt 30 Nm plus an additional 90° (1/4 turn)
^
Replace
^
Lubricate threads and contact surface
^
Tighten to 30 Nm to measure radial play, do not turn further
2. Bolt with pressure relief valve
^
27 Nm
^
Opening pressure 1.3 to 1.6 bar pressure
3. Oil spray jet
^
For piston cooling
4. Connecting rod bearing cap
^
Note installation position
^
Due to the separation procedure (cracking) of connecting rod, cap only fits in one position and only to the corresponding connecting rod.
^
Affiliation to cylinder mark - B
^
Installed location: Markings - A - point to belt pulley side
5. Bearing shell
^
Note installation position
^
Do not interchange used bearing shells
^
Axial play new: 0. 10 to 0.35 mm Wear limit: 0.4 mm
^
Measure radial clearance with Plastigage(R): New: 0.02 to 0.06 mm Wear limit: 0.09 mm. Do not turn crankshaft when checking radial
clearance
6. Connecting rod
^
With cracked bearing cap
^
Only replace as a set
^
Affiliation to cylinder mark - B
^
Installed location: Markings - A - point to belt pulley side
7. Circlip
8. Piston pin
^
If difficult to move, heat piston to 60° C
^
Remove and install using a drift VW 222 A