Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Front Crankshaft Seal: Service and Repair
Seal, Belt Pulley Side
Special tools, testers and auxiliary items required
‹› Seal Remover (3203)
‹› Counter Support (3415)
‹› Assembly Tool (T10053)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Torque Wrench (40-200 Nm) (V.A.G 1332)
Removing
-
Remove the ribbed belt. Refer to => [ Ribbed Belt ] See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Ribbed
Belt.
-
Remove the toothed belt, refer to one of the following:
=> [ Toothed Belt, with Divided Toothed Belt Guard ] See: Timing Components/Timing Belt/Service and Repair/Removal and
Replacement/Toothed Belt, With Divided Toothed Belt Guard.
=> [ Toothed Belt, without Divided Toothed Belt Guard ] See: Timing Components/Timing Belt/Service and Repair/Removal and
Replacement/Toothed Belt, Without Divided Toothed Belt Guard.
-
Remove the crankshaft toothed belt gear. To do this, secure the gear using (3415).
-
To guide the (3203), thread the gear bolt into the crankshaft by hand until seated.