Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Install the engine mount bracket to the cylinder block from above and tighten the bolts hand tight.
‹› Note the different length of the bolts. Bolt - 3 - is approximately 25 mm shorter than bolts - 1 and 2 -.
‹› Bolt - 1 - can be installed through the hole in the wheel housing and tightened.
-
Lower the engine using (10-222A) until the lower bolt - 3 - can be tightened.
-
Tighten all bolts to 45 Nm.
-
Install the engine mount. Tightening specifications, refer to => [ Fastener Tightening Specifications ] See: Specifications/Engine Assembly -
Fastener Tightening Specifications.
-
Tighten the engine mount to engine mount bracket bolts - arrows - hand tight, by bringing the contact surfaces into contact using (10 - 222 A).