Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-854001.png)
Oil Filter: Procedures
Engine oil: draining or extracting; changing oil filter and filling engine oil
Warning!
On engines with standing oil filter module, the oil filter should be changed before the oil change.Removing the filter element will open
a valve and oil in the filter housing will flow automatically into the crankshaft housing.
The oil drain plug is equipped with a permanent seal, therefore the oil drain plug must always be replaced.
Warning!
Torque settings must not be exceeded
A torque figure that is too high may lead to leaks or even damage the oil pan.
Special tools, testers and auxiliary items required
-
Oil extractor V.A.G 1782
-
Oil absorbent towel VAS 6204/1
Engine oil, draining or extracting
Perform the following work procedure:
-
Extract engine oil using old oil collecting and extracting unit V.A.G 1782.
or
-
Remove oil drain plug
-
Drain engine oil.
-
Screw in new oil drain plug with sealing ring hand-tight.
-
Fill motor oil.
Engine oil capacities, refer to Fluid Capacity Charts for appropriate model and year.
Installation notes and disposal regulations
Disposal regulations
Warning!
Never dispose of oil filter in household waste.
Engine oil and oil filter should be used properly, according to national legislation.
Only dispose of in designated containers at the responsible receiving location.
Observe disposal regulations!
Installation notes
Warning!
Oil new O-rings before installation.
Avoid engine oil drips on components in engine compartment.
Oil filter, replacing: 2.0 L TFSI engines
Special tools, testers and auxiliary items required.
