Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Specified value: infinite (Infinity).
If the specified value was not obtained:
-
Replace the faulty Knock Sensor (KS) 1 (G61)/Knock Sensor (KS) 2 (G66).
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin (VAG1598/42).
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J623). Refer to => [ Engine Control Module J623, Removing and Installing ] See: Engine
Control Module/Service and Repair/Engine Control Module J623, Removing and Installing.
-
Using a Multimeter, Check the Knock Sensor electrical harness connector to the Motronic Engine Control Module (ECM) (J623) electrical
harness connector T60 for an open circuit.