Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace the Motronic Engine Control Module (ECM) J623.
-
Install the engine cover with air filter..
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory.
2. If necessary, erase the DTC memory.
3. If the DTC memory was erased, generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
-
End of diagnosis.