Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-1902003.png)
-
Switch the ignition off.
If the specified value was not obtained:
-
Check the Ignition Coil electrical harness connector terminal 1 to the Motronic Engine Control Module (ECM) Power Supply Relay (J271 )
terminal 2/87 for an open circuit.
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified values were obtained:
Checking activation
CAUTION!
Do not touch the Ignition Coils connecting parts or adapter cables during the following test.
-
Disable the power supply to the Fuel Injectors ( N30, N31, N32, N33) by removing Fuse 29 (on fuse panel B) from the fuse holder SB29, in the
E-box, plenum chamber.
-
Using a diode test lamp, check the Ignition Coil electrical harness connector terminals 1 to 3 for voltage.
-
Operate the starter.
The LED should flicker.
-
Switch the ignition off.
If the LED flickers and the voltage was OK:
-
Replace the faulty Ignition Coils with Power Output Stage (N70, N127, N291, N292).
If the LED does not flicker:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin (VAG1598/42).
