Eos (1F7) L4-2.0L Turbo (BPY) (2007)
NOTE
If a connection error is indicated for Seat
Occupant Recognition Module not
found", an "ERROR" indicator on the VAS
5052 / VAS 6150 screen is highlighted.
^
Check all connections.
^
Restart application by pressing EXIT".
^
Switch ignition key ON and then OFF
^
Begin procedure again.
If error continues, try rebooting scan tool and re attempt to perform programming update.
After programming is complete or verified flash was already applied,
^
Disconnect VAS 6103/2 pods connector and VAS 6103 from scan tool.
^
Reconnect 5052/3 diagnostic cable to VAS 5052 I VAS 6150 tester and reconnect vehicle Data Link Connector.
^
Reconnect and lock Seat Occupant Recognition Module 10 pin connector to body 10 pin connector. Be sure that the connector snaps locked.
^
Switch ignition ON.