Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Switch the ignition off.
If the specified value was obtained:
-
Replace the Low Fuel Pressure Sensor (G410).
If the specified value was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Test Box 105 Pin (VAG1598/42).
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J623). Refer to => [ Engine Control Module J623, Removing and Installing ] See:
Powertrain Management/Computers and Control Systems/Engine Control Module/Service and Repair/Engine Control Module J623, Removing
and Installing.
-
Using a Multimeter, check the Low Fuel Pressure Sensor (G410) electrical harness connector terminals to the Motronic Engine Control Module
(ECM) (J623) electrical harness connector T60 terminals for an open circuit according to the wiring diagram.