Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Suspension Control Pressure Sensor/Switch: Service and Repair
Left Rear Level Control System Sensor
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1410)
Removing
-
Disconnect the connector - 1 -.
-
Remove the bolts - 2 - from the lower transverse link.
-
Remove bolts - arrows - from the subframe.
-
Remove left rear level control system sensor ( G76).
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› The left rear level control system sensor lever must point toward the outside of the vehicle.
-
After replacing, perform a headlamp basic setting via the Guided Fault Finding function with the Vehicle Diagnostic, Testing and Information
System (VAS 5051).
Tightening Specifications