Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Rear Knuckle: Procedures
Wheel bearing housing, trailing arm (Eos), assembly overview
1 -
Cover
2 -
Mounting bracket
3 -
Coupling rod
^
Connects stabilizer bar with longitudinal control arm/wheel bearing housing
4 -
Bolt
^
90 Nm plus an additional 45° turn
^
Observe tightening sequence
^
Always replace after removal
5 -
Trailing link
6 -
Bolt
^
8 Nm
7 -
Right Rear ABS Wheel Speed Sensor G44 / Left Rear ABS Wheel Speed Sensor G46
^
Can be checked in Guided Fault Finding with Vehicle Diagnosis, Testing and Information System VAS5051/6
^
Before inserting sensor, clean inner surface of mounting hole and coat with Polycarbamide grease G 000 650
8 -
Wheel bearing housing
9 -
Bonded rubber bushing
10 -
Washer
11 -
Nut
^
40 Nm