Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Otherwise strut tube may be canted in hole of wheel bearing housing.
-
Pull off wheel bearing housing downward from strut tube and lower using engine/transmission jack (V.A.G 1383 A) as far until strut tube hangs
freely.
-
Tightly tie wheel bearing housing to console/subframe using binding wire.
-
Remove engine/transmission jack (V.A.G 1383 A ) from below wheel bearing housing.
CAUTION!
‹› Do not leave engine/transmission jack (V.A.G 1383 A) below vehicle any longer than necessary.
-
Remove wiper arms Windshield washing system; wiper arms, removing and installing
-
Remove plenum chamber cover.
-
Remove the hex bolts - arrows - for upper strut mount and remove suspension strut.
Installing
Installation Position of Spring Retainer
-
Insert suspension strut, one of the two markings - arrows - must point in direction of travel when doing this.
Tighten hex bolts - arrows - for upper strut mount.